Articles Stat:
Number of Articles: 109Number of Proceeding pages: 655
Papers View: 151583
2nd international Power Electronics, Drive Systems and Technologies Conference
2nd international Power Electronics, Drive Systems and Technologies Conference In date 2010-03-21 by ,دانشگاه علم و صنعت in City Tehran was held. please refer to the following link to download all the papers of conference proceedings: _PROCEEDINGS 2nd international Power Electronics, Drive Systems and Technologies Conference
Copyright © 2016 - All Rights Reserved - Symposia
Accepted papers in 2nd international Power Electronics, Drive Systems and Technologies Conference
Solar Power System for Experimental Unmanned Aerial Vehicle (UAV); Design and Fabricatio
Grid Connected DG Systems Based on Z-Source NPC Inverters
An Analytical Method for Selecting Optimized Crowbar for DFIG with AHP Algorithm
A D-Q Synchronous Frame Controller for Single-Phase Inverters
A Novel Variable-Speed Wind Energy System Using Permanent-Magnet Synchronous Generator and Nine-Switch AC/AC Converter
Investigation of Influential Factors on Passive Islanding Detection Methods of Inverter Based Distributed Generation
Investigation of Droop Characteristics and X/R ratio on Small-Signal Stability of Autonomous Microgrid
A Survey on Different Direct Power Control Algorithms of DFIGs
Enhanced Predictive Direct Power Control of DFIG
Control of Hybrid Wind/ Energy Storage Power Generation Systems during Voltage Disturbance
Reversing the Power Flow in the Looped Electrical Distribution Network by Using a Cascaded H-bridge D-SSSC
Investigation of Small Signal Dynamics of Inverter- Based Distributed Generation in Grid-Connected and Autonomous Modes of Operation
Application of a New Multivariable Sliding Mode Controller for the Single Machine Infinite Bus Systems
Fuel Cell Distributed Generation System's Control in Autonomous Mode
Power Electronic Interface in a 70 kW Microturbine- Based Distributed Generation
Enhancing the Reliability of Single-Phase CHB-Based Grid-Connected Photovoltaic Energy Systems
A Novel Temperature Estimation Method for Solar Cells
Experimental Comparison between the Electric Efficiencies of Two Different Types of Switched Reluctance Generators
Optimizing Cogging Torque Reduction in Slot Opening Shift Method for BLDC motor by RSM
Analysis of Linear Switched Reluctance Motor with Longitudinal Flux Linkage Using 2D-FEM Compared to 3D-FEM
Optimization of Driving Force of Linear Switched Reluctance Motor
Design of Thrust Ripple Minimization in Wound Secondary Linear Synchronous Motors by Response Surface Methodology (RSM)
Robust Stator Winding Fault Detection in Induction Motors
Finite Element Analysis of Brushless Doubly-Fed Machine Under Stator Winding Faults
A New Control Strategy of DFIG-Based Wind Turbines Under Unbalanced Grid Voltage Conditions
Conducted EMI Modeling and Reduction in a Flyback Switched Mode Power Supply
Study on Periodic and non Periodic Frequency Modulation Techniques for EMI Suppression in SMPS
Performance Analysis of Hybrid Energy Storage in Different Driving Cycles
Energy Recovery in a Metro Network using Stationary supercapacitors
Speed Control for Interior Permanent Magnet Synchronous Motor Drives Based on Brain Emotional Learning Based Intelligent Controller in The Field-Weakening Region
A Simple Position Sensorless Control Strategy for Four-Switch Three-Phase Brushless DC Motor Drives Using Single Current Sensor
Toward a Common Framework for Analysis of High Performance Controls of PMS Motor Drives
A Modified DTC for Induction Motor Drive System Fed by Indirect Matrix Converter Using Active Learning Method
A New C-Dump Converter For Bifilar Winding Switched Reluctance Motor
Matrix converter for two-phase induction Motor Application:Analysis, Modeling and Simulation
Position Sensorless Direct Torque Control of Brushless DC Motor Drives Based on Sliding Mode Observer Using NSGA-II Algorithm Optimization
A Complete Excitation-Shaft-Bearing Model to Overcome The Shaft Induced Voltage And Bearing Current
A New Approach to DTC-ISVM for Induction Motor Drive System Fed by Indirect Matrix Converter
An Experimental Examination of a Fuzzy Logic- Based DTC Scheme
Emotional Controller (BELBIC) based DTC for Encoderless Synchronous Reluctance Motor Drives
Combined Vector and Direct Torque Control Methods for IPM Motor Drives Using Emotional Controller (BELBIC)
A Novel PSO Based Technique For Optimizing The DOH In Hybrid Electric Vehicles To Improve Both The Fuel Economy And Vehicle Performance And Reduce The Emissions
Predictive Control of Traveling Wave Ultrasonic Motors using Neural Network
Sensorless Predictive Torque Control of Induction Motor by means of Reduced Order Observer
A Comparative Study of DTC-SVM with Three- Level Inverter and an Improved Predictive Torque Control Using Two-Level Inverter
New Converter for Switched Reluctance Motor Drive With Wide Speed Range Operation
Current ripple analysis in a decoupled SVPWM controlled dual two-level inverter fed open-end winding induction motor drive
Improved Vector Control of Dual Mechanical Port Machine for Hybrid Electric Vehicle
Power Electronics - Key Technology for Renewable Energy Systems
Zero-Current Transition Interleaved Boost Converter
Impact of Different Control Strategies on Cycloconverter Harmonic Behavior
Discontinuous Energy Pump Source Inverters
Full Modeling a Series HEV Based on BZS-NSI
A Generalized Algorithm for Switch Reduction in Multioutput Single-Phase Inverters with/without Z-source impedance network
A Novel Fault-Tolerant Four-Leg AC/AC Converter Capable of Compensating Unbalanced Source/Load
A Novel Method on Adaptive Backstepping Control of Buck Choppers
Wind Farm Based Doubly Fed Induction Generator Using a Novel AC/AC Converter
Grid Interaction of DG Units with a Modified Mixed Cascade Flying Capacitor Multicell Inverter
Reduction of switching frequency using reference phase disposition PWM technique in multilevel H-bridge inverters
Operation of AC Chopper as Downstream Fault Current Limiter and Overvoltage Compensator
A Method Based on Imperialist Competitive Algorithm (ICA), Aiming to Mitigate Harmonics in Multilevel Inverters
Power Quality Improvement Based on Novel Power Electronic Transformer
Simulation and Implementation of a New Topology in Multi-Output DC-DC Resonant Converters Based on SwRC Converters
Flexible D-STATCOM Performance as a Flexible Distributed Generation in Mitigating Faults
A Comparative Study of AC/DC Converters Used in High Current Applications
Transformerless Hybrid Buck Converter with Wide Conversion Ratio
Double Stage Switch Mode AC Voltage Regulator
Coordinated design of PSSs and SSSC-based damping controller based on GA optimization technique for damping of power system multi-mode oscillations
Analysis and Design of a New Choke Less Interleaved ZVS Forward-Flyback Converter
Common Mode Voltage Reduction with a modified Hysteresis Current Control Strategy
A New Method for Minimizing of Voltage Stress Across Devices in Z-Source Inverter
Fast Detection of Open-Switch Faults with Reduced Sensor Count for a Fault-Tolerant Three-Phase Converter
Implementation of Three-phase grid-connected inverter Using TMS320LF2407A microprocessor
Analysis and Design of a New Soft switching Interleaved Converter Using an Integrated Transformer
Basic Families of Medium-power Soft-switched Isolated Bidirectional dc-dc Converters
Comparison of 2.3kV Neutral Point Clamped, Series Connected H-Bridge and Auxiliary Series Connected H-Bridge Five-Level Converters
A New Mixed Stacked Multicell Converter with Interesting Advantages
A Common-mode Voltage Reduction Strategy for a DFIG with a Three-Level Back-to-Back Converter
Averaged Modeling Of A New Bi-directional DC-DC Converter
New Method for Inrush Current Mitigation Using Series Voltage-Source PWM Converter for Three Phase Transformer
A Novel SPWM Strategy for Single- to Three-Phase Matrix Converter
A New Topology For The Three-Phase to Three- Phase Cycloconverters
Double Input Z-Source DC-DC Converter
Analysis of A New Quasi Resonant DC Link Inverter
Modeling of PFC Rectifiers by PWA-Fuzzy Method
Optimal Piecewise Affine Large Signal Modeling of PFC Rectifiers Based on Reinforcement Learning
A New Strategy for Control of Cascaded H-bridge Rectifiers with Uneqaul Loads
Nonlinear Model Control of DC/AC Voltage Converter of an Isolated Three Phase Power Network
Fault Tolerant Nine Switch Inverter
Leading and Lagging Legs Power Loss Analysis in ZVS Phase-Shift Full Bridge Converter
Thermal Design, Modeling and Simulation of Air Forced Cooling Heat Sink for Thyristor Controlled Reactor (TCR)
Simulation of 24-Pulse Autotransformer Based AC–DC Converter Employing Pulse Multiplication with Direct Torque Controlled Induction Motor Drive Load
Fixed Frequency Sliding Mode Controller for the Buck Converter
Enhancement of Overall Coupling Coefficient and Efficiency of Contactless EnergyTransmission Systems
Fault-tolerant Operation of a Medium Voltage Drive Based on the Cascaded H-bridge Inverter
A Novel Zero-Voltage-Transition Bridgeless PFC With Reduced Conduction Losses
Compensating Procedures for Power Quality Amplification of AC Electrified Railway Systems Using FACTS
electrified railway systems; static synchronous compensator; static VAR compensator; power factor improvement; voltage regulation.
A New phase sequence Detector for the Three-Phase Rotary Loads
Study of the Impact of the Drive System of a Three Phase Induction Motor in Energy Efficiency and Power Quality: A Case Study-Bucket Elevator
Power Quality Analysis In The Bus Bar Feeding The Instrument Equipment At The Airport Marechal Rondon
Application of VIPWM Technique on Three Phase Shunt Active Filters
A New DSTATCOM Topology Based on Stacked Multicell Converter
Dynamic Voltage Restorer Using Push-pull Inverter
Using Magnetizing Reactances of Transformer in Hybrid Active Power Filter
Selective Compensation of Voltage Harmonics in an Islanded Microgrid
LFFC Schems Base on B-Spline Network with Static Output Feedback Controller for UPS Inverters
A Novel Single-Phase Six-Switch AC/AC Converter for UPS Applications
A High Performance Controller for Parallel Operation of three-Phase UPSs Powering Unbalanced and Nonlinear Loads